A trouble with JDM programmer

[Neo]

I heard about that and Magneto has just confirmed it doesn't work over a USB to Serial converter. So we will have to see other options. If you have more PCI ports, you might be able to fix a Com port card that costs around LKR 1600.

[Rksk]

These days its a huge cost to me.
because i have many costs like tutions, daily bus fee(over Rs100) and ect.
pls send me the programmer. i will do something to resolve it.

pls tell to magneto to write working programms to chips before posting.

thank you so much.

[ Post made via Mobile Device ]

[Neo]

Yes, he will write a small code when he has some free time. But unfortunately he is very busy these days. The other point is, if you can tell me whether you have free PCI ports in your PC, may be I can buy one for you?

[Rksk]

yes. I have free PCI ports.
i don't like to waste your and magneto's valuble time. u can help me when u have free time.

thank you.

[ Post made via Mobile Device ]

[Rksk]

...

[ Post made via Mobile Device ]

[Neo]

Hi, We haven't forgotten you
Magneto confirmed that everything works perfectly after he tested programming a PIC with some ultrasonic sensors and indicators. He told me that he will submit some pics soon on that so we all can see. According to the current facts, it seems the problem is with your PC.

However I remember when we check your PC over teamviewer few months ago, the serial ports were working? Can you check them again. If those are working, it seems like a software issue.

[Rksk]

Hi,
very very sorry for the late. I late because of my mechine was in some bugs and i was resolving them.

Today i checked my searial ports and COM2 was worked fine with hyperterminal.

hyperterminal.JPG (10.46 KiB) Viewed 9371 times

this port was working also when I try with the JDM.
I think the is a problem in other pins of searial port like power supply, ...
is there any way to check them?

thankz.

[ Post made via Mobile Device ]

[Neo]

I'm not sure whether it is possible to check signal line without a scope. It can be a difficult task to find maximum voltage level which should be 12 V.

Can you pass this to Magneto and handle the issue with him. He knows more than me on the current progress....

[Rksk]

Can you pass this to Magneto and handle the issue with him. He knows more than me on the current progress....

now it's passed about 20days. but still Magneto haven't answered to my PMs.

neo,
can u tell him to send the programmer back to me?

i'll try to solve it my self!

[ Post made via Mobile Device ]

[Neo]

Emailed him. I'm sure he will reply as soon as possible.