ROBOT.LK

Gateway of last resort is not set

C 1.0.0.0/8 is directly connected, serial0/1

C 3.0.0.0/8 is directly connected, serial0/0

C 192.168.1.0/24 is directly connected, loopback0


Configure RIP on Router A

RouterA#configure terminal

RouterA#(config)#router rip

RouterA#(config-router)#network 3.0.0.0

RouterA#(config-router)#network 1.0.0.0

RouterA#(config-router)#network 192.168.1.0

RouterA#(config-router)#exit

RouterA#(config)#


Now verify these configuration on router A with command us under:

RouterA#show ip route

To check the routing protocol with this command.

RouterA#show ip protocols



RouterB#show ip route

Gateway of last resort is not set

C 1.0.0.0/8 is directly connected, serial0/1

C 2.0.0.0/8 is directly connected, serial0/0

C 192.168.1.0/24 is directly connected, loopback0


Configure RIP on Router B

RouterB#configure terminal

RouterB#(config)#router rip

RouterB#(config-router)#network 1.0.0.0

RouterB#(config-router)#network 2.0.0.0

RouterB#(config-router)#network 192.168.2.0

RouterB#(config-router)#exit

RouterB#(config)#



Now verify these configuration on router B with command us under:

RouterB#show ip route

RouterC#show ip route

Gateway of last resort is not set

C 2.0.0.0/8 is directly connected, serial1

C 3.0.0.0/8 is directly connected, serial0

C 192.168.3.0/24 is directly connected, loopback0


Configure RIP on Router C

RouterC#configure terminal

RouterC#(config)#router rip

RouterC#(config-router)#network 2.0.0.0

RouterC#(config-router)#network 3.0.0.0

RouterC#(config-router)#network 192.168.3.0

RouterC#(config-router)#exit

RouterC#(config)#



Now verify these configuration on router C with command us under:

RouterC#show ip route

From your information i understand the Rip routing thanks for that.

I don't know how the load balancing is done in the Rip routing. If you know please help me to understand this topic. Or can we done the load balancing between the two unequal cost link with the Rip routing??

And Thanks in Advance.........

Please have a look at How Does Load Balancing Work?