its with shenal now, il tell him to upload a pictureNeo wrote:A picture is worth a thousand words !!!
Can you update with some pictures.
how to build a drawing machine
-
- Moderator
- Posts: 78
- Joined: Wed Jul 20, 2011 3:06 pm
- Location: Sri lanka,Wattala
Re: how to build a drawing machine
Re: how to build a drawing machine
Here are some pictures of drawing machine.
Sorry for late updates
Sorry for late updates
Re: how to build a drawing machine
Very nice. Praveen has done a good job. I would like to give a little idea. I think it would be better if you could use another stepper motor instead of the free wheel. It could otherwise be inaccurate when the pen is loaded with some friction. Just an idea. I know time has already become a problem.
Re: how to build a drawing machine
How about line bearings without an other stepper
Re: how to build a drawing machine
As long as it can handle the friction of the pen, technically a bearing is okay. However in practical terms, you will have to do some additional work to get it to work. Since this topic is very long, please start a new topic for other questions.
Re: how to build a drawing machine
So, what happen to this project? is there any updates?
Now it's octomber' end.
[ Post made via Mobile Device ]
Now it's octomber' end.
[ Post made via Mobile Device ]
Re: how to build a drawing machine
I have also requested the same from Praveen but didn't get any reply so far
Re: how to build a drawing machine
Images of the Drawing Machine(Without USART)
Re: how to build a drawing machine
Excellent... this is very nice!!!
Re: how to build a drawing machine
can someone tell me how to write the firmware to micro-controller to drive the stepper motors.Iam going to use mach3