How to connect the rf receiver to a switching system???

Electronics & Electrical Engineering Topics
Post Reply
User avatar
Prashanth
Posts: 1
Joined: Wed Oct 15, 2014 2:26 pm

How to connect the rf receiver to a switching system???

Post by Prashanth » Wed Oct 15, 2014 3:05 pm

In the rf module, the encoded signal is sent to the receiver and it will be decoded thereafter...
After decoding, what really happens???
And how to use the decoded signal as if to connect it to a switching system???

[ Post made via Mobile Device ] Image
Top
User avatar
SevenZero
Major
Major
Posts: 263
Joined: Sun Nov 01, 2009 8:37 pm

Re: How to connect the rf receiver to a switching system???

Post by SevenZero » Wed Oct 15, 2014 8:11 pm

You need to define your own messaging protocol. An example is given below.

RELAY1ON
RELAY2ON
RELAY1OFF
RELAY2OFF

ON reception of these messages, a message decoder then calls relevant On/Off functions of the microprocessor/controller.
Top
Post Reply

Return to “Electronics & Electrical Engineering”