I inserted the PIC16F877A microcontroller to the ZIF socket of the programmer in the right direction
and pluged serial cabel from PC to Programmer board.
Then I configered WinPic800 with selecting JDM programmer as the hardware.
Then i tried to Flash a hex file to my PIC.
it wasn't success because of I forgot to select device.
after it I selected the device and tried again.
but it wasn't success.
The programmer's LED didn't blink.
winpic800 shows ErrMsg as below winpic800's log is below..
Opening COM1
Detected -> UNKNOWN
Device Erased .: Ok
[ Verifying during programming ]
Programming Code - 8192 word
Programming Data - 256 byte
Programming ID - 4 word
Error ...
After it I tried with other COM port.
it too did't success.
I can't find the bug.
Pls help me.