Parallel Port Control Program v2.1 (ppcp)
-----------------------------------------

This program allows you to control pins 2-9 (D0-D8) from your computer parallel port. This software is much quicker than v1.0 with new features. And the most important - it is FREEWARE -   :-)


Changes made in v2.1
--------------------
-support Win 2000 and WinXP operating systems (NT core)
-support 8 instead of 4 outputs
-support on/off repeatedly
-support JFet's and NPN Transistors (2 different circuits)
-support other port addresses like 378H,278H,3BCH
-fixed bug in v1.0 with counters
-quicker software than v1.0

Attention!!!
This software has not yet been fully tested.
If you experience problems during operation then first try to restart the program or even restart your computer.
If the problem still remain then mail me at micgm@yahoo.com. Also check my homepage for bug fixes, new software or suggestions at www.geocities.com/micgm/



For comments,questions and suggestions mail me at micgm@yahoo.com
Homepaged at www.geocities.com/micgm/

Mic - 5/2004



